Filter
Top Products
ASSEMBLY
TW144 01/11 Assembly Section 3-5
© 2011 Alamo Group Inc.
ASSEMBLY
Attach the Axle Arms to the Main Axle maintaining
Dim. A approximately equal to Dim. B when clamp
bolts are tighten. However, these Dim. may vary
slightly if needed to help level the Mower Deck from
side to side.
Note: Axle arms may be moved on the main tube
to the desired wheel tread but it is always
recommended that wheels be placed as wide as
possible for stability. Figure Asm-R-0139.
CONTROL RODS - PULL TYPE
Attach the two level-lift control rods to the lower lugs on tongue and to lugs on the rear axle tube using pins,
washers and cotter pins.
Note: The adjusting nuts on control rods should be to rear of machine and should always be adjusted with
equal tension on both rods. Figure Asm-R-0140 & Asm-R-0141.