SAFETY
SE42 03/08 Safety Section 1-14
© 2008 Alamo Group Inc.
SAFETY
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
(SG-14)
Never attempt to lubricate, adjust, or remove material from the Implement while it is in
motion or while tractor engine is running.
(SG-20)
Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners, worn
or broken parts, and leaky or loose fittings. Make sure all pins have
cotter pins and washers. Serious injury may occur from not maintaining
this machine in good working order.
(SG-21)
Do Not fill gasoline tank while engine is running. Refuel only after engine has cooled down.
If gasoline is spilled, move machine away from the area of the spill and avoid creating any
source of ignition until the gasoline has evaporated.
(SG-28)
Perform service, repairs and lubrication according to the maintenance section. Ensure the
unit is properly lubricated as specified in the lubrication schedule and all bolts and nuts are
properly torqued. Failure to properly service, repair and maintain this Implement in good
operating condition could cause component failure and possible serious injury or even
death.
(SG-35)
U
se cau
ti
on an
d
wear pro
t
ec
ti
ve g
l
oves w
h
en
h
an
dli
ng s
h
arp o
bj
ec
t
s suc
h
as
bl
a
d
es,
knives, and other cutting edges. Be alert to worn component surfaces which have sharp
edges. Sharp surfaces can inflict severe laceration injuries if proper hand protection is not
worn.
(SG-37)
All Safety Shields, Guards and Safety devices including (but not
limited to) - the Deflectors, Chain Guards, Steel Guards, Gearbox
Shields, PTO integral shields, and Retractable Door Shields should
be used and maintained in good working condition. All safety devices should be
inspected carefully at least daily for missing or broken components. Missing, broken,
or worn items must be replaced at once to reduce the possibility of injury or death
from thrown objects, entanglement, or blade contact.
(SGM-3)