Filter
Top Products
SAFETY
SE42 03/08 Safety Section 1-13
© 2008 Alamo Group Inc.
SAFETY
Maintenance and Service Safety Instructions and Practices
O
n
l
y
t
ranspor
t
th
e
I
mp
l
emen
t
b
e
hi
n
d
a proper
l
y s
i
ze
d
an
d
equ
i
ppe
d
Tractor which exceeds the weight of the Implement by at least 20%. DO
NOT transport the Implement behind a truck or other type of vehicle.
Never transport the Implement and another Implement connected in
tandem. Never transport the Implement at speeds over 20 MPH.
(STI-6)
Your driving vision may be reduced or impaired by the tractor, cab, or implement. Before
driving on public roadways identify any limited vision areas, and make adjustments to your
operating position, mirrors, and the implement transport position so that you can clearly
see the area where you will be traveling, and any traffic that may approach you. Failure to
maintain adequate vision of the public roadway and traffic can result in serious injury or
even death.
(STI-10)
Make sure the PTO shield, integral driveline shields, and input shields
are is installed when using PTO-driven equipment. Always replace any
shield if it is damaged or missing.
(S3PT-8)
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement. Place the Implement on the ground or securely
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work.
(S3PT-9)
Always disconnect the main PTO Driveline from the Tractor before performing service on
the Implement. Never work on the Implement with the tractor PTO driveline connected and
running. Rotating Parts, Blades or Drivelines could turn without warning and cause
immediate entanglement, injury or death.
(S3PT-11)
N
ever
i
n
t
er
f
ere w
ith
f
ac
t
ory-se
t
h
y
d
rau
li
c ca
lib
ra
ti
ons.
A
ny c
h
ange
i
n ca
lib
ra
ti
on cou
ld
cause a failure of the equipment and may result in injury. (SBH-13)
Always maintain the safety signs in good readable condition. If the safety signs are
missing, damaged, or unreadable, obtain and install replacement safety signs immediately.
(SG-5)
D
o no
t
mo
dif
y or a
lt
er
thi
s
I
mp
l
emen
t
.
D
o no
t
perm
it
anyone
t
o mo
dif
y or a
lt
er
thi
s
Implement, any of its components or any Implement function.
(SG-8)