Filter
Top Products
OPERATION
SE4 05/05 Operation Section 4-16
© 2005 Alamo Group Inc.
OPERATION
8.2 Mower Pre-
O
peration Inspection
/S
ervice
Before each mower use, a complete inspection and service is required to ensure the mower is in a good and
safe working condition. Damaged and/or broken parts should be repaired and/or replaced immediately. To
ensure the mower is ready for operation, conduct the following. OPS-R-0007
The operator’s manual and decals affixed on the
unit contain important instructions on the safe and
proper use of the equipment. Maintain these
important safety features on the implement in good
condition to ensure the information is available to
the operator at all times.
• Ensure the manual canister is secured to the
equipment with the operator’s manual inside.
• Ensure all decals are in place and legible.
Replace missing, damaged, and unlegible
decals. OPS-U- 0011
• Perform scheduled lubrication as detailed in the maintenance section.
• Inspect that the 3-point hitch pins are the
proper size, correctly installed, and secured to
the tractor lift arms with retaining pins inserted.
• Ensure that a properly rated safety tow chain is
equipped securing the mower to the tractor.
• Check that the driveline is securely attached to
the tractor and the clamping cone is seated in
the groove of the PTO shaft. OPS-R-0008_C
• Ensure deflectors and/or chainguards are in
position and not damaged. Replace worn,
broken, and missing pieces. OPS-R-0038