Filter
Top Products
14
100583
ELECTRIC CHAIN SAW
®
Flat File
Depth
Gauge
Tool
Depth Gauge
Depth
Gauge
Slot
Front Corner
CLEANING AND
MAINTENANCE
Continued
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced
as cutters are sharpened. After every second
or third sharpening, reset cutter depth gauges.
1. Place depth gauge tool firmly across top
of two cutters. Make sure depth gauge
enters slot in depth gauge tool (see Fig-
ure 21).
2. Use medium flat file. File depth gauge
level with depth gauge tool.
3. Remove depth gauge tool. With flat file,
round off front corner of cutter depth
gauge (see Figure 22).
Figure 21 - Depth Gauge Tool On Chain
Figure 22 - Round Off Front Corner Of
Depth Gauge
After several hand filings, have authorized
service center or sharpening service machine
sharpen chain. This will insure even filing.
Replacing Saw Chain
Replace chain when cutters are too worn to
sharpen or when chain breaks. Only use
replacement chain noted in this manual. Al-
ways include new drive sprocket when re-
placing chain. This will maintain proper driv-
ing of chain.
Note:
For proper chain and drive
sprocket, see Replacement Parts.
STORAGE
If storing saw for more than 30 days, follow
steps below.
1. Drain oil tank.
2. Remove and clean guide bar and chain.
Clean guide bar and chain by soaking
in petroleum based solvent or mild soap
and water mixture.
3. Dry guide bar and chain.
4. Place chain in container filled with oil.
This will prevent rust.
5. Wipe a thin coating of oil over surface
of guide bar.
6. Wipe off outside of saw body. Do this
with soft cloth dampened with a mild
soap and water mixture.
7. Store chain saw
• in a high or locked place, out of
children’s reach
• in a dry place
• in a carrying case or with scabbard
over guide bar
• with oil cap tight and saw upside
down to prevent excess oil seepage
REPLACEMENT
PARTS
WARNINGICON G 001
WARNING: Use only replace-
ment parts described in this
manual. Use of other parts could
damage saw or injure operator.
Purchase these parts from your local dealer.
Part
Number Description
EL-7
097572-03S Guide bar, 40,6 cm (16")
091375S Chain, 40,6 cm (16")
EL-1
097570-01S Guide bar, 35,5 cm (14")
091374S Chain, 35,5 cm (14")
LNT-3
097568-02S Guide bar, 30,5 cm (12")
091373S Chain, 30,5 cm (12")
LNT-2
097567-01S Guide bar, 25,4 cm (10")
091371S Chain, 25,4 cm (10")
097566-01S Guide bar, 20,3 cm (8")
091369S Chain, 20,3 cm (8")
Pole Saw
104302-01S Guide bar, 20,3 cm (8")
104301S Chain, 20,3 cm (8")
General
075752 Drive sprocket
079417-03 Wrench/Screwdriver