Filter
Top Products
4 |
3 blower/vac assembly
Assembling Blower
Follow the steps below to assemble the
blower. IMPORTANT: You must install the
blower tube before installing the bottom
inlet cover. e bottom inlet cover hooks
onto the blower tube. e blower will not
run unless the bottom inlet cover is locked
into place.
1. Slide the blower tube onto outlet
on front of blower/vac housing (see
Figure 3-1). Make sure the moulded
hook on the blower tube is positioned
below the blower.
2. Position front of bottom inlet cover
over blower tube hook (see Figure
3-2).
3. Pivot bottom inlet cover to bottom
of blower/vac housing. Slightly press
locking lever on bottom inlet cover
to allow cover to lock into place (see
Figures 3-3 and 3-4).
Figure 3-4: Pressing locking lever
WARNING: To Reduce The
Risk of Personal Injury or Electric
Shock – Disconnect from power
source before assembling or
changing attachments.
Figure 3-1: Sliding blower tube into place
Figure 3-2: Attaching bottom inlet cover to
blower tube hook
Figure 3-3: Pivoting bottom inlet cover to
blower/vac housing
118034
1
2
3
4