Filter
Top Products
7
www.remingtonpowertoolscom
ENGLISH
2. Plug the charger into any standard 120
Volt 60 Hz electrical outlet. IMPORTANT:
Do not charge by means of an engine
generator or DC power source. Use only
120V AC.
3. Slide the charger onto the battery pack as
shown in Figure 2. The LED will light up,
Let the battery pack charge until red LED
turns off. After the initial charge, under
normal usage, your battery pack should be
fully charged in 3 to 9 hours.
CHARGING BATTERY
The battery pack is not fully
charged at the factory. Before
attempting to charge the bat-
tery pack, thoroughly read all
Safety Instructions.
4. Unplug charger. Remove the charger by
sliding off (See Figure 3).
5. Place the battery pack in the tool and be
certain that it is inserted fully into the tool
cavity until it “clicks” into place.
IMPORTANT CHARGING NOTES
1. After normal usage, your battery pack
should be fully charged in 3 to 9 hours. If
the battery pack is run-down completely,
it may take up to 9 hours to become fully
charged. Your battery pack was sent from
the factory in an uncharged condition. For
best performance charge battery until red
LED turns off.
Allow the battery to cool
down 30 minutes before charging after
using the blower/sweeper. NOTE: A
hot battery placed in the charger will not
charge.
2. DO NOT charge the battery pack in an
air temperature below 40°F (4,5 °C) or
above 105°F (40,5 °C). This is important
and will prevent serious damage to the
battery pack. Longest life and best per-
formance can be obtained if battery pack
is charged when air temperature is about
75°F (24°C).
3. While charging, the charger may hum and
become warm to touch. This is a normal
condition and does not indicate a prob-
lem.
4. If the battery pack does not charge prop-
erly
• Check current at receptacle by plugging
in a lamp or other appliance.
• Check to see if receptacle is connected
to a light switch which turns power off
when you turn out the lights.
• Move charger and battery pack to a
surrounding air temperature of 40°F
(4,5°C) to 105°F (40,5 °C)
• If the receptacle and temperature are
OK, and you do not get proper charging
contact DESA Power Tools.
5. The battery pack should be recharged
when it fails to produce suffi cient power
on jobs which were easily done previously.
DO NOT CONTINUE using product with
its battery pack in a depleted condition.
6. To prolong battery life, avoid leaving the
battery pack on charger for extended pe-
riods of time (over 30 days without use).
Although overcharging is not a safety
concern, it can signifi cantly reduce overall
battery life.
7. The battery pack will reach optimum per-
formance after being cycled 5 times during
normal usage. There is no need to run the
batteries down completely before recharg-
ing. Normal usage is the best method of
discharging and recharging the batteries.
Figure 3 - Remove Charger
Figure 2 - Sliding Charger onto Battery
RECHARGEABLE BATTERY
The charger is designed to use standard house-
hold 120 volt 60 Hz power.
1. Plug cord from charger into charger base.
(See Figure 1)
Figure1 - Plug Charger into Base