Filter
Top Products
■ MOUNTING ENGINE (SE1)
1. Push the driveshaft housing toward the clutch
housing and rotate it by hand to check that the
driveshaft is engaged with the gears.
2. Insert the driveshaft housing into the clutch
housing until it bottoms, and align the positioning
holes on the clutch housing and the shaft tube
and install the screw. When difficult to engage,
twist the engine slightly.
3. Fasten the clamp securely with two screws.
Tighten the screws gradually by turns.
■ CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint
on the top of the carburetor. (SE2)
■ CONNECTING SWITCH WIRES
• Connect the switch wires between the engine
and the main unit. Pair the wires of the same
color.
■ INSTALL THE HANDLE
1. Remove both screws from the handle.
2. While spreading the handle at the mounting
hole, position the handle on the outer tube as
shown.
3. Reinstall the two mounting screws in the handle,
but do not tighten them at this time.
One side of the handle is recessed to receive the
hex nuts.
4. Locate the handle at the best position for
operator comfort (usually about 10inches (25cm)
ahead of the throttle lever), and secure it by
tightening the knob at the handle base.
NOTE
IMPORTANT
6. Set up
❲
14
❳
SE1
SE2
SE3