Filter
Top Products
English – 39
TECHNICAL DATA
Recommended original and replacement bar and chain combinations for USA
Following is a list of recommended cutting equipment for the RedMax chain saw model G5300. The combinations of
power head, bar and chain have been tested and found to be in accordance with the kickback requirements of ANSI
B175.1–2000.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
Chain saw model RedMax G5300 met the kickback performance requirements of ANSI B175.1-2000 when tested with
the combinations of bars and saw chains listed below. The saw chain Oregon 33 SL is also classified as a low kickback
saw chain since it met the requirements for low kickback saw chain outlined in ANSI B175.1-2000.We recommend to
use only the listed combinations of bars and chains for chain saw model RedMax G5300. Other chain saw models may
not meet the kickback requirements when equipped with the listed bar and chain combinations.
Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of
powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-03 Chainsaws and Z62.3-04 Chainsaw
Kickback standards.
We recommend that you as replacement use the listed bars and chains or ”Type C Low-Kickback Saw Chains” which
are available at your dealer.
Kickback information
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
Bar and chain combinations
The following recommended combinations of bar and saw chain are type approved for your chain saw.
Bar Chain
Length, inch Art No.
Pitch,
inch/mm
Gauge,
inch/mm
Max. nose
radius
Type Drive link
16 G5316 0,325 0,050 10T Oregon 33 SL 66
18 G5018 0,325 0,050 10T Oregon 33 SL 72
20 G5020 0,325 0,050 10T Oregon 33 SL 78