Filter
Top Products
(HE-EX2 only)
1. Attach the gearbox to the shaft tube as
aligning the positioning holes and
fasten the screw (A). Fasten the clamp
bolt (B) firmly. (SE1)
(A) Screw
(B) Clamp bolt
(B) Tightning Torque: 70~130 in-lb
(8~15 N.m)
2. Place the blade between the cutter
holders (A) and (B) while locking the
gear shaft by putting the bar, one of the
tools provided, through the key holes
on the holder(A) and the gearcase. Use
the socket and the screwdriver as
shown in the picture below to tighten
the blade mounting bolt. (SE2)
(1) Blade mounting bolt (Left-handed)
(2) Cutter holder (B)
(3) Blade
(4) Bar
(5) Cutter holder (A)
US-12
EXZ2460S-PH
(B)
(A)
HE-EX2 SE1
RMS-EX SE1
HE-EX2 SE2
(RMS-EX only)
■ SWEEPER ASSEMBLY (SE1)
1. Push one of the drum axles onto either
of the two gearcase output shafts. If
necessary, rotate the drum axle until
the clevis pin hole in the axle aligns
with the matching hole in the gearcase
output shaft.
2. Use a clevis pin and hitch pin to secure
the drum axel to the shaft.
3. Slide the recessed end of a sweeper
drum assembly over the assembled
axle, and then push the drum down the
axel until it bottoms at the clevis pin.
(1) Clevis Pin
(2) Hitch Pin
(3) Cotter Pin
(4) Drum Axle
(5) Drum Assembly
The two drum assemblies are identical,
but each drum must be installed with its
recessed end facing toward the gearcase.
IMPORTANT
4. Use a cotter pin to secure the drum
assembly on the axle (see inset) . The
cotter pin is designed to fit tightly
against the outboard end of the drum,
so you may need to compress the drum
face slightly during installation.
5. Repeat Steps 1-4 to install the
remaining axle and drum assembly.
6. Set up