Filter
Top Products
26
8. Operation (Optional blade usage EX2-BC only)
Change the loop handle to the J-handle for safe
operation. (OP4)
(1) Bracket: 3583-14101
(2) J-handle: 6367-14200
■ STARTING THE ENGINE
Please refer 5.For safe operation (P.9~11),
8.Operation (P.21~22).
• The product is equipped with a centrifugal clutch
mechanism, so the cutting attachment begins to
rotate as soon as the engine is started by putting
the throttle into the start position. When starting
the engine, place the product onto the ground in
a flat clear area and hold it firmly in place so as
to ensure that neither the cutting part nor the
throttle come into contact with any obstacle
when the engine starts. (OP5)
■ CUTTING METHOD
a) Use the front left side cutting.
b) Guide the blade from your right to left with it
tilted slightly to your left. (OP6)
c) When mowing a wide area, start working from
your left end to avoid interference of cut grass.
d) The blade may be seized by weeds if the engine
speed is too low, or the blade cuts too deep into
weeds. Adjust the engine speed and cutting
depth according to the condition of object.
• If the grass or other object gets caught in the
blade, or if the unit starts to shake or vibrate,
turn off the engine and check the whole unit.
Change the blade if it has been damaged.
• Turn off the engine and make sure the blade has
completely stop before checking the blade, and
removing any object got caught in.
WARNING
WARNING
IMPORTANT
EX2-BC
OP4
EX2-BC
OP6
EX2-BC
OP5