Filter
Top Products
US-13
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L
U
S
• If waste gets stuck and causes
blockage around the intake air cooling
vent or between the cylinder fins, it may
cause the engine to overheat, and that
in turn may cause mechanical failure
on the part of the hedge-trimmer.
■ BLADES
Oil blades each gas tank filling (MA5).
• Make sure that the blade bolts are
well tightened.
• The blade assembly is designed to
automatically compensate for any
play between the blades.
Check the cutting edges and reform with
a flat file. (MA6)
Point :
1. Keep the end corner sharp.
2. Round the root of the edge.
3. Do not use water when using a grinder.
•When mounting the blade, make sure
to fasten the spacer, washer and bolt,
then fasten the nut.
(1) Bolt
(2) Plate
(3) Spacer
(4) Nut
■ SHARPENING (MA7)
Always keep the file or sharpener at an
angle of 45° to the blade, and:
• Always grind in the direction of the
cutting edge;
• Note: files cut only in one direction; lift
the file from the blade when returning
to start a new pass;
•Remove all burr from the edge of the
blade with a slip stone;
• Remove as little material as possible;
• Before refitting the sharpened blades,
remove filings and then apply grease.
Do not try to sharpen a damaged blade:
change it or take it to a Service dealer.
IMPORTANT
WARNING
IMPORTANT
MA5
MA6
MA7
MA8
MA9
MA10
8. Maintenance
■ SAFETY LOCK (MA8)
•Stop operation when the safety lock
is defective.
• Safety lock is the device not to
accelerate the throttle lever without
intention. While pushing the safety lock,
you can accelerate the throttle lever.
1. Check if the throttle lever does not
move when you do not push the safety
lock.
2. Check if the throttle lever moves when
you grasp or release it while pushing
the safety lock.
3. Check if the safety lock returns to its
original position when you release your
hand from safety lock.
• If you find any defects at the checks
above, contact your nearest servicing
dealer for repair.
(1) Safety lock
■ REDUCTION GEARBOX
Refill gear housing every 50 working
hours (MA9). Use greese pump. Feed
greese until it comes out of the base of
blades.
Grease nipple: A type
■ ANTI-VIBRATION SYSTEM
• The deformed or damaged anti-
vibration system may cause of the
breakages like getting rickety or
falling off of engine and/or blade.
• [HTZ2460/HTZ2460L] Check
periodically if the rubber cushions are
not deformed or damaged.
• [CHTZ2460/CHTZ2460L] Check
periodically if the springs are not
deformed or damaged.
WARNING
WARNING