Filter
Top Products
❲
28
❳
11. Optional blade usage
speed is too low, or the blade cuts too deep into
weeds. Adjust the engine speed and cutting
depth according to the condition of object.
• If the grass or other object gets caught in the
blade, or if the unit starts to shake or vibrate,
turn off the engine and check the whole unit.
Change the blade if it has been damaged.
• Turn off the engine and make sure the blade has
completely stop before checking the blade, and
removing any object got caught in.
■ OPERATION
1. Check the bolt to fasten the blade and be sure
the bolt has no fault, and no abrasion.
2. Be sure that the blade and the holder have been
fastened according to instruction and the blade
turns smoothly without abnormal noise. (OPT7)
• The rotating parts fastened incorrectly may
cause serious accident to the operator.
• Make sure that the blade is not bent, warped,
cracked, broken or damaged.
• If you find any error to the blade, discard it
and change new one which is certified by
RedMax.
■ By using the shoulder strap, hang the unit on
your right side. Adjust the strap length so that
the cutting head may become parallel to the
ground.(OPT8)
Make sure to use shoulder strap and debris
guard. If not, it is vary dangerous when you slip
or lose your balance.
■ CONTROLLING BLADE BOUNCE
• Kick out can cause serious personal injury.
Carefully study this section. It is important that
WARNING
WARNING
WARNING
WARNING
OPT7
OPT8