RedMax BCZ2500S Brush Cutter User Manual


 
MOUNTING ENGINE (SE1)
1. Push the driveshaft housing toward the clutch
housing and rotate it by hand to check that the
driveshaft is engaged with the gears.
2. Insert the driveshaft housing into the clutch
housing until it bottoms, and align the positioning
holes on the clutch housing and the shaft tube
and install the screw. When difficult to engage,
twist the engine slightly.
3. Fasten the clamp securely with two screws.
Tighten the screws gradually by turns.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint
on the top of the carburetor. (SE2)
CONNECTING SWITCH WIRES
Connect the switch wires between the engine
and the main unit. Pair the wires of the same
color.
INSTALLING HANDLE
Mount the handle to the shaft tube and clamp it
at a location that is comfortable to you. (SE3)
(1) About 19 inches (48cm)
INSTALLING DEBRIS GUARD
Put the debris guard on the gear box, attach it
with the 4 screws and hardware provided. (SE4)
(1) debris guard
(2) plate
(3) screw
IMPORTANT
6. Set up
(BCZ2500S, BCZ2500SU)
SE1
SE2
(1)
SE3
(1)
(2)
(3)
SE4
13