Filter
Top Products
❲
26
❳
11. Optional blade usage
• When sharpening, removing, or reattaching
the blade, be sure to wear thick, sturdy
gloves and use only proper tools and
equipment to prevent injury.
■ SET UP THE BLADE
1. Detach the line head assembly and the shaft
completely. (OPT4)
2. Put on the blade, making the marked side face
the holder, put the holder and the cover on, and
fasten the blade with the bolt and washer.
(OPT4)
(1) Cover: 6420-13280
(2) Holder: 6019-13250 (Holder, bolt, washer
are come with the unit)
Change the loop handle to the J-handle for safe
operation. (OPT5)
(1) Bracket: 3583-14101
(2) J-handle: 6367-14200
■ BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clamp up or down until unit balances with
head just touching on the ground. (OPT6)
■ STARTING THE ENGINE
Please refer 5.For safe operation (P.9~10),
8.Operation (P.17).
• The product is equipped with a centrifugal
clutch mechanism, so the cutting attachment
begins to rotate as soon as the engine is
started by putting the throttle into the start
position. When starting the engine, place the
product onto the ground in a flat clear area
and hold it firmly in place so as to ensure
that neither the cutting part nor the throttle
come into contact with any obstacle when
the engine starts. (OPT7)
WARNING
IMPORTANT
WARNING
OPT5
OPT7
OPT6
(1)
(2)
OPT4