Filter
Top Products
Ensure the power and the gas has been shut
off.
1. Re-connect pilot wire (side B) to new board. See
Fig. 35.
CONNECT THIS END
TO NEW PC BOARD
SPARK LUG
CONNECT THIS END
TO EXISTING PILOT
WIRE
Fig. 37
EXISTING PILOT
WIRE
Page 13
P/N 241169 Rev.-3
2151 Eastman Ave., Oxnard, CA 93030 805-278-5300 Fax 800-777-7026 www.raypak.com
Technical support is available M-F, 5:30 AM to 5:00 PM PST, at 800-947-2975 or 800-627-2975
INSTALLING PILOT HI TENSION WIRE EXTENSION SIZES 335A TO 407A:
Side
‘A’
Side
‘B’
Fig. 35
INSTALLING PILOT HI TENSION: 206 TO 267A:
Ensure the power and the gas has
been shut off.
1. Re-connect pilot wire (side B) to new
board with new extension Fig. 36 &
Fig. 37.
2. Connect side ‘A’ to existing pilot wire
and center protective sleeve over
connection.
Fig. 36