Filter
Top Products
21
ment for excess water, and watch the pump
unit while it is operating to see if water drips
from any of the plumbing. If you can identify the
location of the leak inside the spa jet unit, tight-
en the clamp or replace the damaged seal.
10. SYMPTOM: THE SPA CONTINUES TO RUN
AFTER IT HAS BEEN SHUT OFF
a. To turn the spa jets on high, press the Pump
button once. To turn the spa jets on low, press
the control twice. To turn the spa jets off, press
the control three times. The spa jets will remain
off for three hours, at which time they will begin
running the filter cycle. At any time after the
spa jets has been shut off, the pump will begin
cycling the water if the temperature falls below
the minimum setting. Note: If the water is
already below the minimum setting, the
pump will not shut off.