Filter
Top Products
15
POSTING THE WARNING SIGN
The warning sign, shown below, must be posted on a wall or fence, where all users of the RESTORATION 5.1
will be able to see it. Whenever the spa is moved, the sign must also be moved and reposted near the spa.
ADJUSTING THE FILTER CYCLE
The spa filter cycle runs automatically to clean the
water in the spa. However, the number of times that
the filter cycle needs to run depends on how often the
spa is used.
If many different people use the spa regularly, then
the water will need to be filtered more often than if it
is only used occasionally by a few. The number of
daily cycles, as well as the length of the cycle can be
adjusted.
The pump can run one to three filter cycles daily. To
change the number of cycles, press the pump and up
buttons at the same time. The number of cycles will
appear in the temperature display. Use the up and
down buttons to select the desired number of cycles.
Each cycle can run for 60, 120, or 180 minutes. To
change the length of the cycle, press the light and up
buttons at the same time. The length of the cycle will
appear in the temperature display. Use the up and
down buttons to select the desired cycle length.
The pump or the light may turn on while you are
adjusting the filter cycle. If this happens, you can turn
the pump or light off once you have finished the
adjustment procedure.