Filter
Top Products
8
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
OPERATION
Drift cutter - used to cut through deep snowdrifts.
Drive speed control lever – used to select forward or
reverse motion and speed of snow thrower.
Traction drive control lever – used to engage power-pro-
pelled for ward or reverse motion of snow thrower.
Auger control lever – used to engage auger motion
(throw snow).
Discharge chute control lever – used to change the
di rec tion the snow is thrown.
Skid plate – used to adjust height of scraper bar from ground.
Toolbox – used to store spare shear bolts, locknuts and
wrench.
Safety ignition switch – must be pushed in for the engine to
start and run. Pull out when snow thrower is not in use.
Electric start button – used for starting the engine.
Recoil (auxiliary) starter handle – used for start ing the
en gine.
Primer – pumps additional fuel from the carburetor to the
cylinder for use when starting a cold engine.
Choke Control – used for starting a cold engine.
ON / OFF switch - used to STOP the engine.
FIG. 8
DEFLECTOR REMOTE
CONTROL LEVER
TRACTION
DRIVE
CONTROL
LEVER
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED
CON TROL LEVER
AUGER
CONTROL
LEVER
MUF FLER
TOOLBOX
HANDLE
KNOB
SKID PLATE
CHUTE
DE FLEC TOR
DISCHARGE
CHUTE
AU GERS
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE
ENGINE. ACTUAL
LOCATION MAY
VARY WITH THE
ENGINE ON YOUR
UNIT.
LIGHT
LH TURN
TRIGGER
DRIFT
CUTTER
CLEAN-OUT TOOL
FREEWHEEL
CONTROL
RECOIL
(AUXILIARY)
STARTER
HANDLE
THROTTLE
/ ENGINE
CONTROL
GAS O LINE
FILLER
CAP
ENGINE OIL CAP
WITH DIPSTICK
SPARK
PLUG
SAFETY
IGNITION
KEY
CHOKE
CON-
TROL
ELECTRIC
START
BUTTON
PRIM ER
FUEL
SHUT-OFF
VALVE
OIL DRAIN PLUG
POWER
CORD
PLUG