Filter
Top Products
-- 6 --
1. Insert the tip ofa scr ewdriver into the latch
area of the vacuum inlet.
Latch
Area
Blower
Outlet
Vacuum Inlet Cove r
Latch Area
2. Gentlytilt the handleof the screwdriverto-
ward the front of the unit to release the
latch while pulling up on the vacuum inlet
cove r with your other hand.
3. Hold the vacuum inlet cover open untilup-
per vacuum tu be is installed.
Vacuum
Inlet
Cover
Vacuum Inlet
c
4. Align the tabs on theinside o f t he vacuum in-
let with th e slots o n t he upper va cuum tube.
Tab
Slot
5. Pushthe upper vacuum tubeinto the vac-
uum inlet. T urn t he tube counterclockwise
until a click is felt to secure the tube to the
blower unit.
6. Align slanted endof lowerva cuum tubeas
shown. Firmly push lower vacuum tube
into upper vacuum tube.
Slanted end of
lower vacuum tube
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE
1. Remove the elbow tube and vacuum bag
by turning the knob counterclockwise to
loosen the elbow tube.
2. Remove the vacuum tubes by t urning the
tubes clockwise.
3. Close the vacuum inlet co ver and make
sure it is latched closed.
4. Reinstall the blower tubes (see BLOWER
TUBE ASSEMBLY).
SHOULDER STRAP ADJUSTMENT
1. Hold the unit as shown with th e muf fler side
facing away from your body and clothes.
2. Pass the shoulder str ap over your head
and onto your right shoulder.
3. Extend yo ur lef t arm toward the rear ofthe
vacuum bag.
4. Adjust shoulder st rap until the vacuum
bag/shoulder strap seam lies between
your thumb and index finger.
5. Make sure air flows freely from the elbow
tube into bag. If bagis kinked, the unit will
not operat e properly.