Filter
Top Products
-- 5 --
ASSE MBLY
WARNING: St op engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum o r
blower tubes. The rotating blades can cause
serious injury. Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
WARNING: If you receive your unit
asse mbled, check each step to insure your
unit is properly assembled and all fasteners
are secure. Follow all sa fety information in
the manual and on the unit.
D A standard screwdriver is required for as-
sembly.
BLOWER TUBE ASSEMBLY
1. Align the rib on the up per blower tube with
the groove in the blower outlet; slide the
tube into place.
NOTE: Knob must be loose enough to allow
blower tube t obeinsert ed inblower outlet. Loos-
en knob by turning cou nterclockwise.
Blower Outlet
Rib
Groove
2. Secure thetube by t urningthe knob clock-
wise.
3. Align the slots on the lower blower tube
with the tabs on the upper blower tube.
Upper Blower Tube
Tab
Slot
Lower Blower Tube
4. Slide the lower blower tube onto theupper
blower tube.
5. Turn the lower blower tube clockwise until
a click is felt to se cure the lower blower
tube to the upper blower tube.
NOTE: When the upper and lower blower
tubes are assembled together proper ly, the
arrows on bot h tubes will be aligned.
6. To remove t he tubes, turn the knob coun-
terclockwise to loosen the tubes; remove
the tubes.
HIGH --SPEED NOZZLE ASSEMBLY
When greater air speed is desired, use the
high--sp eed nozzle.
1. Align the slots on the no zzle with the tabs
on the lower blower tube.
High--
Speed
Nozzle
Tab
Slot
Lower Blower
Tube
2. Slide the nozzle ont o the lower blower tube.
3. Turn the nozzle clockwise until a click is
felt to secure the nozzle to the low er blow -
er tube.
VACUUM BAG ASSEMBLY
1. Open the zipper on the vacuum bag and
insert the elbow tube.
2. Push the small end of the elbow tube
through the small opening in t he bag.
Small Opening
Zipper
Opening
Elbow
Tube
Rib
NOTE: Make sure ed ge of the small openin g
is flushagain st the flared area oftheelbow tube,
and the rib on the elbo w tube is on the bottom.
3. Closethezipperonthe bag.Make surethe
zipper is closed completely.
4. Remove blower tubes fr om engine.
Rib
Groove
5. Inserttheelbow tube intothe bloweroutlet.
Make sure elbow tube rib is aligned with
the blower outlet groove.
6. Turnknobclockwiseto s ecure elbowtube.
VACUUM TUBE ASSEMBLY
WARNING: Stop engine and be sure
the i mpeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury.