Filter
Top Products
14
Mowing
SWEEPING-- Thefanning actionof therotat-
ing line can be used for a quick and easy
clean up. Keep the line parallel to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
EDGER ATT ACHMENT
OPERA TING POSITION
Heavy Shoes
Long Pants
Eye Protection
A
L
W
A
Y
SWE
A
R:
Hearing
Protection
Head Protection
When operating unit, stand as shown and
check for the following:
S W ear eye protection and heavy clothing.
S Keep right arm slightly bent with right hand
holding the trigger handle of powerhead.
S Keep left arm extended with left hand
holding the handle.
S Keep unit below waist level.
S Adjust edger wheel for proper cut depth.
WARNING: Never attempt to adjust
the edgerwheel whenthe unit is in operation.
Always stop the powerhead, wait until the
bladestopsturning,and disconnectthespark
plug before m aking adjustments.
EDGING
Asyoubecomefamiliarwithuseofyouredger
attachment,youwillbeabletodetermineyour
own operating pace.
Conditions such as depth of cut and material
being cut will regulate the speed and time re-
quired for your edging job.
S Allow the engine towarm upbefore you begin
edging.
S Increase the engine speed before placing the
blade in the cut. For best results, run the en-
gine at full throttle while cutting.
S Al wa ys work g o i n g awa y fro m p e o p l e and
solid object s such as wa ll s, l arge stones,
trees, automobiles, etc.
S Becareful whenedging neartrees or valuable
plants. The high speed metal blade may cut
roots and cause damage to the plants.
S If the blade stalls, immediately move the unit
back slightly toallow t he bladeto restart. Ifthe
blade continues to stall, stop the engine, dis-
connect the spark plug, andinspect for block-
age or damage.
WARNING: Keep the blade area
clean. Always release the throttle trigger ,
push and release the engine ON/ST OP
switch, disconnect the spark plug and make
sure the blade has completely stopped turn-
ing before cleaning.
SETTING THE EDGING DEPTH
WARNING: N ever attempt to adjust
the cut depth when the engine is running. Al-
ways release the throttle trigger,wait until the
blade stops turning, push andrelease theen-
gine ON/STOP switch, and disconnect spark
plug before making adjustments.
Depth Adjustment
Knob
1. Loosen the depth adjustment knob.
2. Slide the wheel to the desired position.
S Raising the wheelwillincrease thecut-
ting depth.
S Lowering the wheel will decrease the
cutting depth.
3. Tighten the depth adjustment knob se-
curely .