Filter
Top Products
8
S Liftuptipofguidebartocheck f orsag. Re-
lease tip of guide bar , then turn adjusting
screw until sag does not exist.
S Tightenchainbrakenutssecurely withthe
bar tool.
Chain Brake
Nuts
S Use the screwdriver end of the bar tool to
move chain around guide bar.
S If chain does not rotate, it is too tight.
Slightly loosen chain brake nuts andloos-
en chain by turning the adjusting screw.
Retighten chain brake nuts.
S If chain is too loose, it will sag below the
guidebar . DO NOToperate thesaw ifthe
chain is loose.
NOTE:Thechainistensioned correctlywhen
theweight o fthe chain doesnot causeit tosag
below the guide bar (with the chain saw sitting
in anupright position), but thechain stillmoves
freely around the guide bar .
WARNING: If the saw is operated
with a l oose chain, thechain could jumpoffthe
guide bar andresult in serious injury to the op-
erator and/or damage the chain making it un-
usable. If the chain jumps off the guide bar , in-
spect each drive link for damage. Damaged
chain must be repaired or replaced.
OPERATION
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR
CHAIN SAW . Compare the illustrations with your unit to familiarize yourself with the location of the
various controls and adjustments. Save this manual for future reference.
Chain Adjustment
Tool
(Bar Tool)
Front Handle
Front Hand Guard
Chain
Bar Oil
Fill Cap
Starter Rope
ON/STOP
Switch
Starter Housing
Fuel Mix Fill Cap
Muffler
Bar Sprocket
Hole
Direction
of Chain
Travel
Guide Bar
Chain Brake Nuts
Chain Brake
Choke/Fast Idle Lever
Throttle
Trigger
Rear
Handle
Cylinder Cover
Throttle
Lock--out
Adjusting
Screw
ON/STOP SWITCH
The ON/STOP SWITCH is used to stop the
engine.
THROTTLE TRIGGER
The THROTTLE TRIGGER controls engine
speed.
THROTTLE LOCK --- OUT
The THROTTLE LOCK--OUT must be
pressedbeforeyoucan squeezethethrottle
trigger.This feature prevents you from acci-
dentally squeezing the trigger.