Filter
Top Products
7
ChainBrake
Chain Brake
Nuts
Bar Tool
Location of shipping spacer
3. Turn adjusting screw on bar counter-
clockwisetomovethetensioningrackas
faras itwill gotowardthefrontof thebar.
Tensioning Rack
Adjusting
Screw
4. Slidethebarbehind clutchdrumuntilbar
stops against clutch drum sprocket.
Mount the bar
5. Prepare the chain by checking the proper
direction. Without followingthe ill ustrationit
is easy t oplacethechainon thesaw inthe
wrong direction. Use the illustration of t he
chain to determine the proper direction.
CUTTERS MUST FACE IN
DIIRECTION OF ROTATION
Tip of
Bar
Cutters
Depth Gauge
Drive Links
6. Place the chain over and behind the
clutch, fitting the drive links in the clutch
drumsprocket.
Place chain onto the sprocket
7. Fit bottom of drive links between the
teeth in the sprocket in the nose of the
guide bar.
8. Fit chain drive links in to bar groove.
9. Pull the bar forward until the chain is
snug inthegroove o fthebar. Ensureall
drive links are in the bar groove.
10. Hold guide bar against the saw frame
and install the chain brake.
11. Replacethechainbrakenutsandtighten
finger tight. Once the chain is ten-
sioned,youwillneedtotightenchainbra-
ke nuts.
CHAIN TENSION (Including units with
chain already installed)
NOTE: When adjusting chain tension,
make sure the chain brake nuts are finger
tight only. A ttempting to tension the chain
when the chain brake nuts are tight can
cause damage.
Checking the tension:
Usethescrewdriverend ofthechainadjust-
menttool(bartool)tomovethechainaround
the bar. If the chain does not rotate, it is too
tight.Iftooloose, thechainwillsagbelowthe
bar.
Chain Brake Nuts
Chain Adjustment
Tool (Bar Tool)
Adjusting the tension:
Chain tension is very important. Chain
stretches during use. This is especially true
during the first few times you use your saw.
Always check chain tension each time
before you start the chain saw.
An adjusting screw (located on the guide
bar)is u sedtoadjustthetensionof th echain
(see illustration).
S Loosen the chain brake nuts.
S Turnadjustingscrew clockwise unti lchain
solidly contacts bottom of guide bar rail.
Adjusting
Screw
Guide bar
S Using the screwdriver end of the bar tool,
roll chain around guide bar to ensure all
links are in bar groove.