Poulan 545186755 Chainsaw User Manual


 
13
Correct GrooveWorn Groove
File Rail Edges
and Sides
Square
Replace the guide bar when the groove
is worn,the guide barisbent orc racked,
or when excess heating orburringof the
rails occurs. If replacement is neces-
sary, use onlythe guide barspecifiedfor
your saw in the repair parts list or on the
decal located on the chain saw.
LUBRICATION
Bar Oil
Fill Cap
S Check bar and chain oil before use
and every 15 minutes while operating
the saw. See
GUIDE BAR AND CHAIN
OIL
under the OPERATION section.
INSPECT AND CLEAN UNIT AND
LABELS
S After each use, inspect complete unit
forloose ordamaged parts. Clean the
unitand labelsusing adamp clothwith
a mild detergent.
S Wipe off the unit and labels with a
clean dry cloth.
SERVICE AND ADJUSTMENTS
CHAIN SHARPENING
Chain sharpening requires special
tools. You can purchase sharpening
tools at an authorized service dealer or
go to a professional c hain sharpener.
WARNING: Avoid accidental start-
ing. Always unplug saw from power
source before installing a bar and/or
chain.
CHAIN REPLACEMENT
WARNING: Wear protective
gloves when handling chain. The chain
is sharp and ca n cut you even when it is
not moving.
Itis normalfora newchainto stretchdur-
ing the first 15minutes of operation. You
should recheck your chain tension fre-
quently and adjust the chain tension as
required. See
CHECK CHAIN TENSION
section.
Replace the old chain when it be comes
worn or damaged. Use only the Low
Kickback replacement chain specified
in the list of available replacementparts.
Thechain mustcomplywithkickbackre-
quirementsofANSIB175.1 whentested
with this saw.
See an authorized service dealer to re-
place an d sharpen individual cutters on
your chain.
TO REPLACE CHAIN:
1. Disconnect the chain saw from the
power source.
2. Turn the unit ups ide down on a flat
surface. Straighten out chain, then
lay it on a flat surface.
Bar N uts
Adjusting
Screw
3. Remove bar mounting nuts, bar
clamp plate, and old chain.
4. Turn the adjusting screw counter-
clockwise to move the adjusting pin
almost as far as it will go to the rear.
Do not remove the adjusting screw
from the unit.
5. Hold chain with cutters facing as
shown.
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Tip of
Bar