Filter
Top Products
-- 5 --
ASSEMBLY
WARNING: Stop engine andbe sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury . Always disconnect the spark
plug before performing m aintenance or ac-
cessing movable parts.
WARNING: If you receive your unit
assembled, check each step to insure your
unit is properly assembled and all fasteners
are secure. Follow all safety inform ation in
the manual and on the unit.
D A standard screwdriver is required for as-
sembly.
BLOWER TUBE ASSEMBLY
1. Align the slots on the lower blower tube
with the tabs on the upper blower tube.
Upper Blower Tube
Tab
Slot
Lower Blower Tube
2. Slide thelower blowertube ontotheupper
blower tube.
3. Turnthe lower blowertube clockwise until
a click is felt to secure the lower blower
tube to the upper blower tube.
NOTE: When the upper and lower blower
tubes are assembled together properly, the
arrows on both tubes will be aligned.
4. Align therib onthe upperblower tubewith
the groove in the blower outlet; slide the
tube into place.
NOTE: Knobmustbelooseenoughtoallow
blower tubes to be inserted in blower outlet.
Loosen knob by turning counterclockwise.
Blower Outlet
Rib
Groove
5. Secure the tubes by turning the knob
clockwise.
6. To remove the tubes, turn the knob coun-
terclockwise to loosen the tubes; remove
the tubes.
HIGH --SPEED NOZZLE ASSEMBLY
When greater air speed i s desired, use the
high--speed nozzle.
1. Align the slots on t he nozzle with the tabs
on the lower blower tube.
High--Speed
Nozzle
Tab
Slot
Lower Blower
Tube
2. Slide the nozzle onto the lower blower tube.
3. Turn the nozzle clockwise until a click is
feltto securethe nozzle tothelower blow-
er tube.
VACUUM BAG ASSEMBLY
1. Open the zipper on the vacuum bag and
insert the elbow tube.
2. Push the small end of the elbow tube
through the small opening in the bag.
Small Opening
Zipper
Opening
Elbow
Tube
Rib
NOTE: Makesureedgeofthesmallopening
is flush against the flared area of the elbow
tube, and the rib on the elbow tube is on the
bottom.
3. Closethezipperonthebag.Makesurethe
zipper is closed completely.
4. Remove blower tubes from engine.
Rib
Groove
5. Inserttheelbowtubeintothebloweroutlet.
Make sure elbow tube rib is aligned with
the blower outlet groove.
6. Turnknobclockwisetosecureelbowtube.
VACUUM TUBE ASSEMBLY
WARNING: Stop engineand be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury.