Filter
Top Products
7
CUTTERS MUST F ACE IN
DIIRECTION OF ROT
A
TION
Tip of
Bar
Cutters
Depth Gauge
Dri
v
e
L
inks
6. Place chain over and behind the clutch
retainer, fitting the drive links in the
clutch drum sprocket.
7. Fit bottom of drive links between the
teeth in the sprocket in the nose of the
guide bar .
8. Fit chain drive links into bar groove.
9. Pullguide barforward untilchain is snug
in guide bar groove. Ensure all drive
links are in the bar groove.
10. Hold guide bar against the saw frame
and install clutch cover.
11. Install bar nuts and finger tighten only.
Once the chain is tensioned, you will
need to tighten bar nuts.
CHAIN T ENSION
(Including units with chain already installed)
WARNING: Wearprotective gloves
when h andlingchain. Thechainis sharpand
can cut you even when it is not moving.
NOTE: When adjusting chain tension,
make sure the bar nuts are finger tight only .
Attempting totensionthe chainwhenthebar
nuts a re tight can cause damage.
Checking the tension:
Use thescrewdriver end of the chainadjust-
ment tool (bar tool) t o move chain around
guidebar.If thechaindoes notrotate,itis too
tight. Ifthechainis tooloose,itwillsagbelow
the bar .
Bar Nuts
Chain Adjustment
Tool
(Bar Tool)
Guid
e
Bar
Adjusting the tension:
Chain tension is very im portant. Chains
stretch during use. This is es pecially true
during the first few times you u se your saw.
Always check chain tension each time you
use and refuel your saw.
An adjusting screw (located on the guide
bar) is used t oadjustthe tensionof the chain
(see illustration).
1. Turn adjusting screw clockwise until chain
solidly contacts bottom o f guide bar rail.
Adjusting
Screw
Guide bar
2. Using bar tool, roll chain around guide bar
to ensure all links are in b ar groove.
3. Lift up tip of guide bar to check for sag.
Release tip of guide bar, then turn ad-
justing screw clockwise until sag does
not exist.
4. While lifting tip of guide bar, tighten bar
nuts securely with the bar tool.
Bar Nuts
5. Use the screwdriver end of the bar tool
to move chain around guide bar.
6. If chain does not rotate, it is too tight.
Slightly loosen bar nuts and loosen
chain by turning the adjusting screw .
Retighten bar nuts.
7. If chain is too loose, it will sag below the
guide bar. DO NOT operate the saw if
the chain is loose.
WARNING: If the saw is operated
with a loose chain, the chain could jump off
the guide bar and result in serious injury.