Poulan 545137231 Chainsaw User Manual


 
7
Adjustment located on clutch cover
Inside
view of
clutch
cover
4. Turn the adjusting screw by hand coun-
terclockwise until the adjusting pin just
touches the stop. This should allow the
pin to be near the correct position.
5. Slide guide bar on bar bolts until guide
bar stops against clutch drum sprocket.
Guide bar
Bar bolts
6. Carefully remove the chain from the pack-
age. Hold chain with the drive links as
shown.
CUTTERS MUST F ACE IN
DIIRECTION OF R OTATION
Tip of
Bar
Cutters
Depth Gauge
Dri
v
e
L
inks
7. Place chain over and behind clutch re-
tainer, fitting the d rive links in the clutch
drum sprocket.
8. Fit bottom of drive links between the
teeth in the sprocket in the nose of the
guide bar.
9. Fit chain drive links into bar groove.
10. Pullguide barforward until chain issnug
in guide bar groove. Ensure all drive
links are in the bar groove.
11. Now, install clutch cover making sure
the adjusting pinis positionedin the low-
er hole in the guide bar. Rem em ber this
pin moves the bar f orward and back-
ward as the screw is turned.
Clutch
Cover
Lower
Hole
Guide Bar
Adjusting Pin
12. Install bar nuts and finger tighten only.
Once the chain is tensioned, you w ill
need to tighten bar nuts.
CHAIN T ENSION
(Including units with chain already installed)
WARNING: Wear protective gloves
when h andlingchain. The chainis sharpand
can cut you even when it is not moving.
NOTE: When adjusting chain tension,
make sure the chain brake nuts are finger
tight only. Attempting to tension the chain
when the chain brake nuts a re tight can
cause damage.
Checking the tension:
Use the screwdriver end of the chain adjust-
ment tool ( bar tool) to move chain around
guide bar. Ifthe chain doesnot rotate,it istoo
tight. Ifthe chainis tooloose, itwillsagbelow
the bar .
Bar Nuts
Chain Adjustmen
t
Tool
(Bar Tool)
Guid
e
Bar
Adjusting
Screw
Adjusting the tension:
Chain tension is very important. Chains
stretch during use. This is especially true
during the first few times you use your saw .
Always check chain tension each time you
use and refuel your saw.
1. Loosen barnutsuntil theyarefinger t ight
against the clutch cover.
2. Turn adjusting screw clockwise until chain
solidly contacts bottom o f guide bar rail.
Adjusting
Screw