Filter
Top Products
5
Right Hand
Left Hand
S
Position your left hand on the front
handlebar so it is in a straight line with
your right hand on the rear handle
when making bucking cuts. Stand
slightly to the left side of the saw to
keep your body from being in a direct
line with the cutting chain.
S
Stand with your weight evenly bal-
anced on both feet.
S
Do not overreach. You could bedrawn
or thrown off balance and lose control.
S
Do not cut above shoulder height. It is
difficult to maintain control of saw
above shoulder height.
KICKBACK SAFETY FEATURES
WARNING:
The following features
are included on your saw to help reduce
hazard of kickback; however, such fea-
tures will not totally eliminate this dan-
ger. Do not rely only on safety devices.
Follow all safety rules to help avoid kick-
back and other forces which can result
in serious injury.
S
Hand Guard: designed to reduce the
chance of your left hand contacting
the chain if your hand slips off the front
handlebar.
S
Position of front and rear handlebars:
designed with distance between han-
dles and “in-line” with each other. The
spread and “in-line” position of the
hands provided by this design work to-
gether to give balance and resistance in
con trolling t h e piv o t of the sa w ba c k t o-
ward the operator if kickback occurs.
S
Reduced-Kickback Guide Bar: de-
signed with a small radius tip which re-
duces the size of the kickback danger
zone. This type bar has been demon-
strated to significantly reduce the num-
ber and seriousness o f kickbacks when
tested in accordance with ANSI B175.1.
Large Radius
Tip Guide Bar
Small Radius
Tip Guide Bar
S
LowKickback Chain hasmetkickback
performance requirements when
tested onthe representative sample of
these chain saws specified in ANSI
B175.1.
Low Kickback Chain
Contoured Depth Gauge
Elongated Guard Link
Deflects Kickback Force
And Allows Wood To
Gradually Ride Into Cutter
WARNING:
Computed Kickback
Angle (CKA) listed on your saw and listed
in the following CKA Table represents the
angle of kickback your bar and chain
combinations will have when tested in ac-
cordance with CSA and ANSI standards.
Computed angles represented in the CKA
column indicate total energy and angle
associated without a chain brake. When
purchasing replacements, considerations
should be given to the lower CKA values.
In all cases, lower CKA v alues represent a
safer operating environment for the user.
S
Tip contact in some cases may cause
a lightning fast
REACTION
, kicking the
guide bar up and back toward the op-
erator.
S
Pinching the saw chain along the tip of
the guide bar may push the guide bar
rapidly back towards the operator.
S
Either of these reactions may cause
you to lose control of the saw which
could result in serious injury. Do not
rely exclusively upon safety devices
built into your saw.
The following guide bar and chain c om-
binations m eet kickback requirements o f
CSA Z62.1 & Z62.3 and ANSI B175.1
when used on saws listed in this manual.
Use of bar and chain combinations other
than those listed is not r ecomm ended and
may not meet the CKA requirements per
standard.