Filter
Top Products
6
weather has been linked to blood vessel
damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength, change in skin color o r texture,
or loss of fe eling in the fingers, hands, or joints,
discontinue the u se of this tool and seek
medical attention. An anti-vibration system
does not guarantee the avoidance of these
problems. Users who operate power tools on
a continual and regular basis must monitor
closely t heir physical condition and the
condition of this tool.
SPECIALNOTICE:Your sawis equipped
with a temperature limiting muffler and spark
arresting screen which meets the
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
law that many internal combustion engines
tobeequippedwith aspark arrestingscreen.
If youoperate achain s awin astate or loc ale
where such regulations exist, you arelegally
responsible for maintaining the operating
condition of these parts. F ailure to do so is
a violation of t he law. Refer to the SERVICE
section for maintenance of the spark
arresting screen.
Failureto followall Safety Rules andPrecau-
tions can result inserious injury . If situations
occur which are not covered in this manual,
use care and good judgement. If you need
assistance, contact your authorized service
dealer or call 1-800--554--6723.
STANDARDS: This saw is listed b y Under-
writer’s Laboratories, Inc., in accordance with:
ANSI B175.1--2000 American National
Standards for Gasoline--Powered Chain
Saws -- Safety Requirements
CSA Z62.1--03 Chain Saws -- Occupational
Health and Safety
CSA Z62.3--96 Chain Saw Kickback Occu-
pational Health and Safety
ASSEMBLY
Protective gloves (not provided) should be
worn during assembly.
ATTACHINGT HE BAR& CHAIN(If not
already attached)
WARNING: If received assembl ed,
repeat all steps to ensure your saw is p roperly
assembled and all fasteners are secure. Al-
ways wear gloves when handling the chain.
The chain is sharp and can cut you even when
it is not m oving!
1. Loosen andremove thebar nutsand the
clutch cover from the saw.
2. Remove the plastic shipping spacer (if
present).
Clutch cover
Bar n uts
Chain adjustment tool
(Bar Tool)
Location of
shipping
spacer
3. Turn adjusting screw on bar counterclock-
wise to move the tensioning rack as far as
it will go toward the front of the bar .
Tensioning Rack
Adjusting
Screw
4. Slide g uide ba r on bar bol ts until guide bar
stops against clutch drum sprocket.
Guide bar
Bar b olts
5. Carefully remove the chain from the pack-
age. Hold chain with the drive links as
shown.
CUTTERS MUST FACE IN
DIIRECTION OF ROT
A
TION
Tip of
Bar
Cutters
Depth Gauge
Dri
v
e
L
inks