Filter
Top Products
9
BEFORE STARTING ENGINE
WARNING: Be sure to read the fuel
handling information in the safety rules sec-
tionof thismanual beforeyou begin.Ifyoudo
not understand the fuel handling information
do not attempt to fuel your unit. Seek help
from someone that does understand the in-
formation or call the customer assistance
help line at 1-800-554-6723.
FUELING ENGINE
WARNING: Remove fuel c ap s lowly
when refueling.
HELPFUL TIP
To obtain thecorrect oilmix
ratio, pour 3.2 ounces of
2-- cycle synthetic oil into
one gallon of fresh gas.
This engine is certified to operate on un-
leaded gasoline. Before operation, gasoline
must be mixed with a good quality synthetic
2-cycle air-cooled en gine oil designed to b e
mixed at a ratio of 40:1. Poulan/Weed E ater
brand synthetic oil is recommended. A 40:1
ratio i sobtainedby mixing 3.2ounces (9 5ml)
of oil wi th 1 ga llo n (4 l iters) of unleaded gaso-
line. Incl ude d w ith this saw is a 3 .2 o unce (95
ml) container of P oulan/WeedEater brand syn-
thetic oil. Pour the entire contents of this con-
tainer into 1 gallon (4 liters) of gasoline to
achieve the proper fuel mixture.
DO NOT USE automotive or marine oil.
These oilswill cause enginedamage. When
mixing fuel follow the instructions printed on
the container. A lways read and follow the
safety rules listed under HANDLE FUEL
WITH CAUTION.
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubri-
cation. Lubrication is provided by the auto-
matic oiler system when the oil tank is k ept
filled. Lack of oil will quickly ruin the bar and
chain. Too little oil will cause overheating
shown by smokecoming f romthe chainand/
or discoloration of the bar.
In freezing weather oil will thicken, making it
necessary to thin bar and chain oil with a
small amount (5 to10%) of #1 D iesel Fuel or
kerosene. Bar and chain oil must be free
flowing for theoilsystemto pump enoughoil
for adequate lubrication.
Genuine Poulan P ROR bar a nd chain oil is
recommended to protect your unit against ex-
cessive wear f rom heat and f riction. Poulan
PROR oil resists high temperature thinning.
If Poulan PROR bar and chain oil is not
available, use a good grade SAE 30 oil.
S Never u se w aste oilfor barandchainlubri-
cation.
S Always stop the engine before removing
the oil cap.
IMPORTANT
Experience indicates that alcohol--blended
fuels (called gasohol or using ethanol or meth-
anol) can attract moisture which leads to sepa-
ration and formation of acids during storage.
Acidic gas can damage the fue l system of an
engine while in storage. To avoid engine prob-
lems, thefuel system should beemptiedbefore
storage for 30 days or longer. Drain the gas
tank, start the engine and let it run until the fuel
lines and carburetor are empty. Use fresh fuel
next season. See STORAGE section for addi-
tional information.
CHAIN BRAKE
Ensure chain brake is disengaged by pulling
the front hand guard back toward t he front han-
dle as far as possible. The chainbrake must be
disengaged before cutting with the saw.
WARNING: The chain must not
move when the engine runs at idle speed. If
the chain moves at idle speed refer t o CAR-
BURETOR ADJUSTMENT within this
manual. Avoid contact with the muf fler. Ahot
muffler can cause serious burns.
To stop t he engine move the ON/STOP
switch to the STOP position.
To start the engine hold th e saw firmly on the
ground as illustrated. Make sure the chain is
free to turn without contacting any object.
Left Hand
on Front
Handle
Starter Rope Handle
Right Foot Through Rear Handle
Use only 15″ -- 1 8 ″ (40 -- 45 cm) o
f
rope per pull.
Hold saw firmly while pulling starter rope.
IMPORTANT POINTS TO REMEMBER
When pulling the starter rope, do notuse the
full extent of the rope as this can cause the
rope to break. Do not let starter rope snap
back. Hold the handle and let the rope re-
wind slowly.
For cold weather starting, start the unit at
FULL CHOKE; allow the engine to warm up
before squeezing the throttle trigger.
NOTE: Do not attempt to cut material with
the choke/fast idlelever inthe FULLCHOKE
position.
HELPFUL TIP
If your engine still does not
start after following these
instructions, please call
1--800--554--6723.
STARTING A COLD ENGINE (or
warm eng ine after running out of
fuel)
NOTE:
In the following steps, when the
choke/fast idle lever is pulled out to the full
extent, the correct throttle setting for starting
is set automatically .