Filter
Top Products
13
S Watch out for branches immediately behind
the branch being pruned. If the chain hits the
rear br anch, d amage to th e unit m ay oc cur.
S Be alert for springback. Watch out for
branches that are bent or under pressure.
Avoid being struck by the branch or the
pruner when the tension in the wood fibers
is released.
S Keep a clear w ork ar ea. Frequently clear
branches out of the way to avoid tripping
over them.
S Long branches should be removed in
several pieces.
PRUNING TECHNIQUE
When ready to cut, accelerate to full throttle
and apply a light cutting pressure. DO NOT
use back and forth sawing action.
Pruning technique
Second cut
Third cut
Collar
First cut
1. Make the first cut 6 inches (15 cm) from
the tree trunk on the bottom of the limb.
Usetopof guidebar tomakethis cut. Cut
1/3 through the diameter of the limb.
NOTE: When making the second and third
cuts, rest the foot of the pruner against the
tree limbthat is being cut to prevent whipping
of the branch.
Foot
2. Next, move 2 -- 4 inches (5 -- 10 cm) far-
ther out on the limb and make a second
cut all the way through the limb.
3. Then,makea finalcutleavinga 1-- 2inch
(2.5 -- 5 cm) c ollar from the trunk of the
tree to avoid damage to the tree.
OPERAT ING INSTRUCTIONS FOR
TRIMMER ATTACHMENT
OPERATING P OSITION
Eye Protection
Long Pants
Heavy Shoes
ALWAYS WEAR:
Cut from your right to your left.
WARNING: Alwaysweareyeprotec-
tion. Never lean over the trimmer head.
Rocks ordebris canricochet orbethrowninto
eyes and face and cause blindness or other
serious injury.
Do not run the engine at a higher speed than
necessary. The cutting line will cut efficiently
whentheengineis runatlessthanfullthrottle.
At lower speeds, there is less engine noise
and vibration. The cutting line will last longer
and will beless likely to“weld” ontothespool.
Always r elease the throttle trigger and allow
the engine to return to idle speed w he n not
cutting.
To stop engine:
S Release the throttle trigger.
S Move the ON/OFF switch to the OFF
position.
TRIMMER LINE ADVANCE
Thetrimmerline willadvanceapproximately2
inches (5 cm) each time the bottom o f the
trimmer headis tappedon thegroundwith the
engine running at full throttle.
The most efficient line length is the maximum
length allowed by the line limiter.
Always keep the shield inplacewhen thetool
is being operated.
To advance line:
S Operate the engine at full throttle.
S Holdthe trimmerheadparalleltoandabove
the grassy area.
S Tap the bottom of the t rimmer head l ightly on
the ground one time. Approximately 2 inches
(5 cm) of line will be advanced with each tap.
Always tap the trimmer head on a grassy
area. Tapping on surfaces such as c oncrete
or asphalt c an cause excessive w ear to the
trimmer head.
If the line is worn down to 2 inches (5 cm) or
less, more thanone tapwill berequired toob-
tain the most efficient line length.
WARNING: Use only 0.080” (2 mm)
diameter line. Other sizes of line will not ad-
vance properly and can cause serious injury.
Do not use other materials such as wire,
string, rope, etc. Wire can break off during
cutting and become a dangerous missile that
can cause serious injury.