Filter
Top Products
11
INSTRUCTIONS
This product requires assembly.
■ Carefully remove the generator and any accessories
from the box.
NOTE: The generator is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
■ Make sure that all items listed in the unassembled
parts list are included. (
See Figure 3.)
■ Inspect the generator carefully to make sure no
breakage or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
generator.
■ If any parts are damaged or missing, please call
1-866-237-1049 for assistance.
PACKING LIST
Generator
Wheel Assembly
Handle Assembly
Foot Assembly
Container of Oil
Warranty Card
Owner's Manual
WARNING:
Do not attempt to operate the generator until assembly
is complete. Failure to comply could result in possible
serious personal injury.
WARNING:
If any parts are missing, do not operate this generator
until the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
WARNING:
Do not attempt to modify this generator or create
accessories not recommended for use with this
generator. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
INSTALLING HANDLE ASSEMBLY
See Figure 4.
■ Locate the following items:
Handle (5)
Left and right handle brackets (2)
4 bolts (3)
4 square curved washers (14)
4 nuts (6)
4 flat washers (4)
■ Align left handle bracket with hole in left side of
generator frame. Insert bolt through handle bracket
and frame. Slide curved washer on end of bolt,
making sure the cupped side of washer faces the
frame. Assemble nut; finger tighten. _
■ Repeat above step with right handle bracket.
■ Put one side of handle inside left handle bracket.
Slide washer over bolt, then insert bolt through the
bracket handle and bracket. Push bolt through so
that it exits on the other side of the handle, then add
another washer and the nut. Finger tighten.
■ Repeat above step with other side of the handle and
the right handle bracket.
■ Return to the first bolt installed. While holding bolt
head steady with 10 mm box-end wrench, use 12 mm
open-end wrench to tighten snugly. (
See Figure 2.)
Repeat with remaining bolts.
WARNING:
Do not attempt to lift the unit by the handle assembly.
If it is necessary to lift the generator, always grasp by
the frame. Use proper lifting techniques to avoid back
injury.
Fig. 4
ASSEMBLY