Filter
Top Products
6
Adjusting the tension:
Chain tension is very important. Chain
stretches during use. This is especially true
during the first few times you use your saw.
Always check chain tension each time you
use and refuel your saw.
You can adjust chain tension by loosening
the bar clamp nuts and turning adjusting
screw 1/4 ofa turn while lifting upon thebar.
S
If chain is too tight, turn adjusting screw
1/4 turn counterclockwise.
S
If chain is too loose, turn adjusting screw
1/4 turn clockwise.
S
Lift upthe tip ofthe barandtighten thebar
clamp nuts with the assembly tool.
S
Recheck chain tension. Tension is correct
when chain does not sag below the bar
but still can be moved around the bar.
Lifts only 1/8 of an inch from bar.
Adjusting
Screw
FUELING & LUBRICATION
FUELING ENGINE
This engine is certified to operate on
unleaded gasoline. Before operation,
gasoline must be mixed with a good quality
2-cycle air-cooled engine oil. We
recommend Poulan/Weed Eater brand oil. If
you do not use this oil, use a good quality
2-cycleair-cooled oildesigned tobe mixed at
a ratio of 40:1 (A 40:1 ratio is obtained by
mixing 3.2 onces of oil with 1 gallon of
unleaded gasoline). When mixing fuel follow
the instructions printed on the container.
Always read and follow the safety rules
relating to fuel before fueling your unit.
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lu-
brication. Lubrication is provided by the au-
tomatic oiler system when the oiltank is kept
filled. Lack of oil will quickly ruinthe barand
chain. Too little oil will cause overheating
shown by smoke coming from the chain
and/or discoloration of the bar.
In freezing weather oil will thicken, making it
necessary to thin bar and chain oil with a
small amount (5 to 10%) of #1 Diesel Fuel or
kerosene. Bar and chain oil must be free
flowing for the oil system to pump enough
oil f or adequate lubrication.
Genuine
POULAN
or
POULAN PRO
bar and
chain oil is recommended to protect your
unit against excessive wear from heat and
friction.
POULAN
or
POULAN PRO
oil resists
high temperature thinning. If
POULAN
or
POULAN PRO
bar and chain oil is not
available, use a good grade SAE 30 oil.
S
Never use waste oil for bar and chain lu-
brication.
S
Always stop the engine before removing
the oil cap.
Oil Cap
Fuel mix cap
STARTING
WARNING:
The chain must not move
when the engine runs at idle speed. If the
chainmoves at idlespeed referto
CARBURE-
TOR ADJUSTMENT
within this manual. Avoid
contact with the muffler. A hot muffler can
cause serious burns.
To stop the engine
move the switch to the
STOP
or
OFF
position.
To start the engine
hold the saw firmly on
the ground as illustrated below. Make sure
the chain is free to turn without contacting
any object.
S
Move switch to the
START
or
ON
position.
IGNITION
SWITCH
ON
OFF
(START)
(STOP)
Hold saw firmly while pulling starter rope.
Use only 15”--18” of rope per pull.
Important points to remember
When pulling the starter rope, do not use
the full extent of the rope as this can
cause the rope to break. Do not let starter
rope snap back. Hold the handle and let
theroperewindslowly.
For cold weather starting, start the unit at
full choke; allow the engine to warm up
before squeezing the throttle trigger.
Do not cut material with the choke lever at
the
FULL
position.