Filter
Top Products
10
AIR FILTER
CAUTION:
Do not clean filter in gasoline
or other flammable solvent to avoid creating
a fire hazardor producing harmful evapora-
tive emissions.
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. Always clean after every
5 hours of operation.
Cleaning the air filter:
S
Clean the cover and the area around it to
keep dirt andsawdust from falling into the
carburetor chamber when the cover is re-
moved.
S
Remove the parts as illustrated.
S
Wash the filter in soap and water.
S
Replace parts.
BAR MAINTENANCE
If your saw cutsto one side, hasto be forced
through the cut, orbeen runwith animprop-
er amount of bar lubrication it may be nec-
essary to service your bar. A worn bar will
damage your chain and make cutting
difficult.
Replace your b ar if bent or the inside rails of
the bar are worn.
S
Clean the oil holes after each 5 hours of
operation
S
Remove sawdust frombar groove period-
ically with a wire or putty knife.
Guide Bar
Groove
Oil Holes
CARBURETOR ADJUSTMENTS
Carburetor adjustment iscritical andif done
improperly can permanently damage your
unit. We recommend you contact an Autho-
rized Service Dealer for adjustments.
IDLE SPEED ADJUSTMENT:
Turn the Idle
Speed Screw clockwise until it stops. Now
turn the screw counterclockwise 4-1/2
turns. This should allow the engine to run
without the chain turning. Ifthe chain moves
at idle speed, do not use your unit. Contact
an Authorized Service Dealer. Idle speed is
correct when engine runs without stalling
and chain does not turn.
MIXTURE ADJUSTMENTS:
If your carbu-
retor includes limiter caps (Plastic caps on
the mixture screws) ,do notforce the screws
beyond the stops of the limiter caps ordam-
age w ill occur. Do not remove these caps.
Small adjustments will affect your unit. Do
not adjust more than 1/16th turn without
checking performance.
CHAIN SHARPENING
Chain sharpening is a complicated task that
requires special tools. We recommended
yourefer chainsharpeningto aprofessional
chain sharpener
IGNITION TIMING
Ignition timing is fixed and nonadjustable.
SPARK PLUG
Replace the spark plug yearly.Gapto .025”.
STORAGE
WARNING:
Stop engine and allow to
cool, and secure the unit before storing or
transporting in a vehicle. Store unit and fuel
in an area where fuel vapors cannot reach
sparks or open flames from water heaters,
electric motors or switches, furnaces, etc.
Store unit with all guards in place. Position
so thatanysharp object cannotaccidentally
cause injury to passersby. Store the unit out
of reach of children.
S
Before storing, drain all fuel from the unit.
Start engine and allow to rununtil it stops.
S
Clean the unit before storing. Payparticu-
lar attention to the airintake area,keeping
it free of debris. Use a mild detergent and
sponge to clean the plastic surfaces.
S
Do not store the unit or fuel in a closed
area where fuel vapors can reach sparks
or an open flame from hot water heaters,
electric motors or switches, furnaces, etc.
S
Store in adryareaout of reach ofchildren.
CAUTION:
It is i mportant to prevent gum
deposits from f orming in essential fuel sys-
tem parts such as the carburetor, fuel filter,
fuel hose, or fuel tank during storage. Alco-
hol blended fuels (called gasohol or using
ethanol or methanol) can attract moisture
which leads to fuel mixture separation and
formation of acids during storage. Acidic gas
can damage the engine.