Filter
Top Products
1. Lift the gas tank end of generator and slide 2x4
between generator and pallet as shown.
The generator is too heavy
to be lifted by one person.
Obtain assistance from others before lifting.
2. Place handle grips on handle assemblies.
3. Place one 5/8” washer into the bottom of each end
cap. Push end caps onto the end of the handle
assemblies.
4. Attach handle assemblies to frame using four screws
and flange nuts. NOTE: Screw on outside of frame.
NOTE: Do not tighten until all screws and flange nuts are
assembled.
5. Lift generator and remove 2x4.
10 — ENG
ASSEMBLY
Read this manual. Do not
attempt to operate
equipment until you have read this Manual for
Safety, Operation, and Maintenance Instructions.
NOTE: Left and right describes the location of a part with
the operator facing the outlet panel.
UNPACKING
1. Locate the parts carton and set aside for later use.
2. Cut wire ties holding generator to pallet and remove
protective wrapping.
3. Remove all packaging, leaving generator on pallet.
IMPORTANT: DO NOT remove generator from pallet.
4. Discard all packaging.
Wire Tie
Protective
Wrapping
ASSEMBLE WHEEL KIT
Tools needed:
2 - 2x4 at least 30” long
1 - 1/2” socket
1 - 1/2” open end wrench
1 - hammer
1 - pliers
Parts bag contains:
2 - Handle Grips
2 - Handle End Caps
4 - Screws, .313-18X1.75
1 - Cotter Pin
2 - Washers, 5/8" X 1.32 X .09
1 - Flat Steel Washer
2 - Axle Spacer
2 - Cap Screw 5/16-18 X 3/4
6 - Flange Nuts
2 - Wheel Brackets
1 - 5/8” Axle Cap
2x4
Screws and
Flange Nuts
Gas Tank
Handle Grip
End Cap
5/8” Washer
Handle
Assembly