Filter
Top Products
9
CONNECTING TO POWER SOURCE
CAUTION: Before connecting router to power source ALWAYS
MAKE SURE SWITCH IS IN THE “OFF” POSITION. Also check that
the power circuit is the same as that shown on specification plate of
the router.
STARTING AND STOPPING THE MOTOR
CAUTION: Before starting the router make sure bit is clear of work
piece and foreign objects. Also keep firm grip on router to resist
starting torque.
The motor units for these routers can be used with either the base having two
handles or the base with the switch-in-handle.
When using the base with two handles, as shown in Fig. 6, the motor is
started and stopped by depressing the rocker switch (A) Fig. 6, into the ON
or OFF position.
When using the base with the switch-in-handle as shown in Fig. 7, be sure the
motor unit power cord (A) is plugged into the handle as in Fig. 7, and the
switch (B) on the motor is set to the ON position. The starting and stopping of
the motor is then controlled by depressing and releasing the trigger switch (C)
in the handle of base.
On applications when it is desirable to keep the motor running without
continually holding in the trigger switch (C) Fig. 7, simply depress the trigger
(C) into the handle and press in the switch locking the button on the side of
the handle. While holding the button in, slowly release the trigger. To stop the
motor, squeeze trigger into handle and release to disengage locking button.
CAUTION: To avoid personal injury or damage to finished work always
allow motor to come to a COMPLETE STOP before setting it down.
Fig. 7
B
A
C