Porter-Cable 6603 Trimmer User Manual


 
9
FOREWORD
The Porter-Cable Model 6603 Shear is designed for cutting cold-rolled steel
sheets up to 18 Ga. and stainless steel sheets up to 20 Ga. You can make
both straight and curved cuts with a minimum radius of 7". The Shear
removes a
¼
" wide continuous curl of waste material without bending or
burring the finished workpiece.
The Porter-Cable Model 6605 Cement Siding Shear is designed for cutting
cement siding. You can make both straight and curved cuts with a minimum
radius of 7". The Shear removes a
¼
" wide piece of waste material.
NOTE: This tool is shipped completely assembled. No assembly time or
tools are required.
HOW TO HOLD THE SHEAR
The gear housing, intermediate plate, and cutting head may
become live if the tool cuts into wiring. To prevent accidental
shock, hold the tool as shown in Fig. 1.
TO START AND STOP THE SHEAR
1. Make sure that the power
circuit voltage is the same as
that shown on the specification
plate of the drill, that the switch
is in the “OFF” position, and
that your hands, body, and
clothing are clear of cutting
head before connecting the tool
to the power circuit.
2. Squeeze the TRIGGER
SWITCH (A) Fig. 2 to start the
motor. Release the trigger to
stop the motor.
3. A lock button (B) Fig. 2 is
provided to keep motor running
without holding the trigger
switch “ON”.
FUNCTIONAL DESCRIPTION
ASSEMBLY
Fig. 1
OPERATION
Fig. 2
A
B