Filter
Top Products
www.petsafe.net 5
Connect the Bottom Frame
Important: Assemble on a level surface.
Gather (Quantity):
• (4) Corner Connectors
• (4) Tube A
• (4) Tube B
1. Begin at any corner. Assemble corner
connector to tube B. Press button on
connector and insert into tube ensuring that
the hole in the tube lines up with the button
on the connector. It should lock into place.
Slip swedged ends of the tubing into the next
piece of tubing.
2. Assemble tube A to tube B. Continue assembling
connectors and tubes. (See Diagram)
A
B
A
B
A
B
Swedged
End
A
B
Complete Kennel Frame
Gather (Quantity):
• (4) Tube A
• (4) Tube B
• (4) Tube E
• (4) Corner Connectors
1. Connect tube E to each of the
bottom corner connectors.
(See Diagram)
2. Insert corner connector
to each tube E.
3. Assemble remaining tubes
per diagram.
B
A
E
E E
E
B
B
B
A
A
A
Install the Gate Post
Gather (Quantity):
• (1) Tube G
• (4) End Rail Clamps
• (2)
5
/
16
x 2 inch Carriage
Bolts with Nut
1. Install the gate post 22 ¼
inches (57 cm) to either side
of the corner upright.
2. With the nut on the outside,
clamp post to the top and
bottom frame rails.
3. Check that post is straight
up and down. Confirm that
all nuts are tight.
22 ¼ inches
(57 cm)
G
Step
1
Step
2
Step
3