Filter
Top Products
4
Prowler
™
720 and 730 Installation and User’s Guide
Operating the Prowler
™
720 and 730 Cleaners
WARNING — Your Cleaner should not be used while people are swimming in the pool. The cable can trip or
entangle swimmers which could result in drowning.
WARNING — Risk of electrical shock or electrocution.
A Ground Fault Current Interrupter (GFCI-USA) or a Residual Current Device (RCD-EUROPE) must
be installed to protect your electric outlet and to prevent any possible electrical shock. Failure to do
so could create an electrical hazard which could result in death or serious injury to pool or spa users,
installers, or others due to electrical shock, and may also cause damage to property.
CAUTION — DO not switch the pool cleaner to “ON” if it is not fully immersed in water. Operating the cleaner out
of water will immediately cause severe damage and will result in loss of warranty.
Allow the cleaner to remain in the pool for 15 to 20 minutes following the end of its cleaning cycle.
This will allow the motors to cool adequately. Do not leave the cleaner in the pool all the time. Always
remember to turn the power supply “OFF” and unplug it from the power outlet before removing the
cleaner from the pool.
Figure 1.
ataDlacinhceT037dna027relworP
ezisloopdednemmoceRteef05x02sretem2.51x1.6
deretlifretawfoemuloV.rh/.lag522,4m61
3
.rh/
027relworP
htgnelelbacgnitaolF
teef06sretem81
037relworP
htgnelelbacgnitaolF
57
teef
32
sretem
rotomevirD
deepshgihCDV42
elbisrembus
rotompmuP
ycneiciffehgihCDV42
elbisrembus
noitacificepsretliFnorcim2elbasueR
noitacificepslacirtcelEzH06/V511
retawniegatloVCDV42