Filter
Top Products
9
Prowler
™
720 and 730 Installation and User’s Guide
Maintaining the Prowler
™
720 and 730 Cleaner
Clean the Filter Bag after every Cleaning Cycle
1. Unplug the power supply. (Keep the plug away from contact with water.)
2. If the unit is in the pool, gently pull the cleaner toward you using the cable until the handle is within reach. Use
the handle (not the cable) to pull the cleaner out of the pool after allowing most of the water to drain from the
unit.
3. Lay the unit on its back on a smooth surface, (in order to prevent scratches on the machine body), unlock and
remove the bottom lid assembly, see Figure 14, Steps 1 - 4.
4. Remove the filter bag from the support bars, see Step 5, turn it inside out and wash off all the dirt with a garden
hose or in a sink. Squeeze the bag gently until the rinse water is clear. If necessary, machine wash the bag using
only cold water with NO DETERGENT!
5. Re-install the bag on the support bars with the label in the center of one of the long sides of the bottom lid, see
Step 6.
6. Re-install the bottom lid assembly onto the body. Push down on it until all (4) locking tabs snap properly into
place.
Section 3
Maintenance
Label
Lock Tabs
1
2
3
4
5
6
Figure 14.