Filter
Top Products
Detail of the outboard bearing assembly.
The bearing is sealed and does not need
lubrication.
Both the shredder hopper and the chipper cone are
assembled with the same hardware and wrench.
21
39B
39A
30
32
Screws (inside)
33
Washers (inside)
31
Nuts (outside)
Detail of the shredder hopper.
32
33
31
27
29
page 20
set
screw
lock
collar
bearing
CAUTION: THE ROTOR WILL
COAST EVEN AFTER THE ENGINE
IS OFF. MAKE SURE THE
ROTOR STOPS TURNING, THEN DIS-
CONNECT THE PLUG WIRE FROM THE
ENGINE BEFORE ATTEMPTING ANY
MAINTENANCE OR CLEAN-OUT. IF THE
ROTOR
IS STILL TURNING, IT MAY
CAUSE SERIOUS PERSONAL INJURY.
▲
!
32
Screw
33
Washer
31
Nut