Filter
Top Products
Operation - Using the Sprayer (continued)
28
0154 2
Priming valve
Pressure adjustment knob
7. Adjust pressure
and agitation as
needed
-Rotate the pressure adjustment knob until the sprayer is running at the
desired pressure.
-O pen priming valve to circulate flow back to the tan k an d create agi tati on.
Open until desired amount of agitation is achieved.
8. Leaving
unattended
If the sprayer must be left unattended at any time:
a) Disconnect power to the sprayer.
b) Relieve system pressure by depressing the gun trigger.
c) Turn off the vehicle. Set brake or block the wheels.
9. Discontinue use if
clogge d or
inoperative
If the sprayer become s clogged or inoperative during use, discontinue use
immediately.
- DO NOT attempt to service while chemicals are in the sprayer and power is
connected.
- Return to service area to review instructions for troubleshooting before
attempting to service.
Note: A reserve, clean container capable of holding at least 16 gallons should be kept for use when the sprayer
tank needs to be emptied temporarily for repairs. It is advisable to purchase a reserve tank suitable for
pesticide storage from Northern Tool and Equipment for use in these circumstances. The container
should be properly labeled as to its contents if it is used.