Filter
Top Products
Assembly (continued)
14
Hoop
Prongs
Strip ½”
Red wir
e
Handl
e
shield
2. Identify sprayer’s
power cords
Identify the power cords shipped with the sprayer.
There are three power cords for the sprayer that you will eventually connect end to
end to power the sprayer. Locate and identify these three cords:
a) The battery power cord and the pump power cord
are shipped connect ed
together to the sprayer.
b) The remote switch power cord is packed separately in the Manual Bag.
3. Separate power
cords
Disconnect the battery power cord from the pump power cord.
4. Prepare wire ends Prepare the wire ends of the sprayer’s battery power cord for connection to
the vehicle battery:
a) Determine the type of end connectors you need to connect to your vehicle’s
battery terminals.
b) Install battery clamps (supplied) or end connectors of your choosing on the
bare ends of the sprayer’s battery power cord wires.
To install battery clamps:
1. Remove red plastic handle
shield from red battery clamp
and slide onto red wire
2. Strip red battery cord wire ½”
3. Insert bare wire under raised hoop
on red battery clamp handle
4. Use a pliers to press hoop down and crimp wire
5. Fold prongs over wire insulation to hold wire in place
6. Push plastic handle shield back over battery clamp handle
7. Repeat for black wire and black battery clamp.
Batter
y
power cord
Pump power cord
Remote switch
power cord
Batter
y
power cord
Pump power cord