Filter
Top Products
Pre-Assembled Parts:
• Corner fittings should be attached to the top bar.
• Swing hooks should be in place on the top bar.
• Hardware for the legs should be in place in the corner fitting prongs.
• Hardware for the support bars should be in place on the legs.
Step Illustration Instructions Hardware Reference
1
Remove the hardware from the prong of a
corner fitting in order to insert one of the
legs.
Part Ref. #: PSHW10
2
Align the two sets of holes and replace the
hardware through the corner fitting prong
and leg to secure the leg. Do not over
tighten the screws. After all parts are
assembled you will need to tighten again.
Part Ref. #: PSHW10
3
Repeat the process for the other leg on the
corner fitting.
Follow the next step before proceeding with
the legs on the opposite side.
Part Ref. #: PSHW10
4
One of the top bar sections should have pre-
assembled hardware. Remove the hardware
and join the two top bar sections together.
Then attach the two center legs with the
bent ends by aligning the holes with those
of the joined top bar and re-insert the
hardware. It is recommended that a
minimum of 2 adults complete this step.
NOTE: It may be helpful to prop up the
side of the top bar without the legs about
one foot off the ground in order to align the
top bar sections and center legs properly.
Part Ref. #: PSHW10
Once the center legs are attached, assemble
the remaining outside legs and then stand
up the swing set frame.
Part Ref. #: PSHW10
5
Remove the hardware from the middle
section of a leg. Match up the holes of the
mid-leg and support bar and re-insert the
hardware through both. Repeat the process
for the opposite side and center legs. It
may be necessary to pull both legs towards
each other in order for the holes to align
properly.
Part Ref. #: PSHW12
6
©
2006 Pacific Cycle, Inc.