Filter
Top Products
6
EN
5. Mount the plastic base on an existing pole.
6. Using the 2 U-bolts, secure the base on the pole
using the 4 washers and bolts.
7. Assemble the wind sensor main body horizontally to
the pole.
8. Use the screw to fi x.
9. Open the battery compartment.
10. Using
a compass, rotate the wind direction part until
the
NORTH
indicator points to the “North”.
11. Press
RESET
.
12. Close the battery compartment.
13. Rotate the sleeve to the right to lock.
SET UP REMOTE RAIN GAUGE
The rain gauge collects rain and takes readings of
the total rainfall over a period of time. The sensor can
remotely transmit data to the base station.
The base station and rain gauge should be positioned
within effective range: about 100 meters (328 feet) in an
open area.
The rain gauge should be mounted horizontally about 1
meter (2-3 feet) from the ground in an open area away
from trees or other obstructions to allow rain to fall
naturally for an accurate reading.
To set up the sensor:
1. Slide the cover up and insert the batteries (2 x UM-
3 / AA), matching the polarity (+ / -).
2. Remove t
he tape.
3. Put a
few drops of water on the cross at the base of
the funnel to check the horizontal level.
If wa
ter remains on 1-4, the gauge is not horizontal.
4. If ne
cessary, adjust the level using the screw.
NOTE
For best results, ensure the base is horizontal to
allow maximum drainage of any collected rain.
4
3
1
2
7
9
8
5
6
12
13
10
11
7
9
1
23
4
WMR100_EN_86L4515-017.indd 6 6/15/06 4:25:43 PM