Filter
Top Products
EN
7
GETTING STARTED
BATTERIES
Batteries are not supplied with this product. You will need
to purchase the following alkaline batteries:
• Main unit 3 x UM-3 / AA 1.5V
• Remote sensor 2 x UM-4 / AAA 1.5V
• UV sensor 2 x UM-3 / AA 1.5V
Insert batteries before first use, matching the polarity as
shown in the battery compartment. For best results,
install batteries in the sensors before the main unit. Press
RESET after each battery change.
NOTE Do not use rechargeable batteries.
shows when batteries are low.
ACCESS FRONT BUTTON PANEL
The front button panel is located inside the right portion
of the main unit. Slide it right to access the buttons.
UNIT
Main Unit &
Remote Sensor
UV Sensor
LOCATION
Temperature / Humidity Area
UV Index Area
CHANGE SETTINGS
1. Press and hold MODE for 2 seconds to enter setting
mode.
2. Press or to change settings.
3. Press MODE to confirm.
TABLE STAND OR WALL MOUNT
Use the stand on the back of the product, or mount it on
a wall with a nail.
THERMO-HYGRO SENSOR (THGR122NX)
This product is shipped with a THGR122NX Thermo/
Hygro Sensor that collects Temperature and Humidity
data. Data can be collected from up to 3 sensors.
Additional sensors sold separately.
BAR609HGAmanual-ENG 05/1/18, 7:11 PM7