Filter
Top Products
EN
12
CLEAR
PARTLY
CLOUDY
CLOUDY RAINY
Indoor
Display
DESIGNATED
DISPLAY
Remote
Display
Channel 1
KINETIC-WAVE
ICON
Remote
Display
Channel 2
Remote
Display
Channel 3
1. Press PRESSURE to select the unit of measurement:
mb or inHg.
2.Press and hold PRESSURE for 2 seconds.
3. Select the altitude (-328 feet to 8203 feet in increments
of approximately 33). Press or to change the
setting. Press PRESSURE to confirm.
WEATHER FORECAST
This product forecasts the next 12 to 24 hours of weather
within a 30 to 50 mile (19 - 31 km) radius with 70 to
75 percent accuracy. The weather forecast is always
displayed.
TEMPERATURE, HUMIDITY AND HEAT INDEX
This product can display current, minimum, and maximum
temperature, humidity percentage and heat index
information collected by the remote sensors and main
(indoor) unit.
Outdoor data is collected and displayed every 40
seconds. Indoor data is collected and displayed every
10 seconds.
SELECT TEMPERATURE UNIT
Slide the
°C / °F switch into the desired location. The
switch is located on the front button panel. The setting
for the main unit overrides the Thermo-Hygro sensor
setting.
SELECT CHANNEL NUMBER
Press CHANNEL to switch between sensors 1-3.
The icon shows the selected sensor.
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEMORY.
NOTE If you use a sensor that collects only temperature
data, humidity will not be shown.
BAR609HGAmanual-ENG 05/1/18, 7:12 PM12