Orbit Manufacturing 91916 Outdoor Timer User Manual


 
11
ENGLISH
the current station to the next station in the cycle. This can
be done during scheduled, manual, or remote actuated
watering.
Section 4: Using the Remote
Control Device
NOTE: The timer will accept commands from the remote control
device only when the selection dial is turned to AUTO or OFF. (If
the selection dial is turned to any other setting, commands from the
Remote Control Device will be stored in memory and executed when
the selection dial is turned to AUTO).
Install a Battery in the Remote Control Device:
Open the battery compartment door.
Install a 9-volt battery in the battery compartment.
Replace the battery compartment door.
To Synchronize the Remote Control Device
with the Timer:
The remote device provided with your timer is already synchro-
nized to your timer. If the remote is not functioning properly or
if you are adding a new remote or RF sensor to your system do
the following:
With the remote device in your hand press the “RF Sync
button on the timer (this will activate a red light on
the timer).
Press the OFF button on the remote or depress the stem of
the RF sensor (the red light should start blinking).
If the red light blinks you have successfully synchronized the
devices. If the light does not blink check that the remote has a
fresh 9V battery or that the RF sensor switch is not OFF and
try the steps again.
To Water All Stations:
Press and release the ALL button on the remote control
device to select all stations for watering.
Press and release the ON “X” MIN button to command the
timer to water all the stations sequentially for the desired
(“X”) number of minutes.
If you wish to advance to the next station before a station's
watering duration is complete, press NEXT.
To Water One Station:
Press the number of the station you wish to water.
Press ON "X" MIN to water the station for the desired ("X")
number of minutes.
To Water More Than One Specific Station:
Press the numbers of the stations you wish to water. (Example:
3, 7, 10, and 6. The timer will water in sequence from lowest
to the highest. 3, 6, 7, 10.) (No matter which order you press
the keys, the timer will water them sequentially from the
lowest to the highest number.)
07WTM002598 57926-24 rA.indd 11 2/16/07 2:07:22 PM