Filter
Top Products
4
GENERATOR FEATURES
Reference 1 - Circuit Breakers. This portable
single phase generator has 1, 15 amp (A) 2, 20A, and
2, 30A push to reset circuit breakers to protect against
electrical overloads.
Reference 2 - 120/240V Receptacle. The locking
device is a 120/240V 30A NEMA L14-30R receptacle.
This receptacle accepts a NEMA plug number L14-
30P. Use this receptacle if installing a transfer switch,
which is compatible with a Gentran transfer switch,
item #16412.
ALWAYS use grounded male plugs. The neutral
line of the generator is mechanically grounded to the
frame. Matching NEMA male plugs must always be
used.
WARNING Contact a licensed electrician
to wire electrical plugs and/or cord-sets. Improper
wiring could result in a fire or electrical shock.
Reference 3 - Grounding Post. Ground the
generator via the grounding post, to a copper pipe or
rod that is driven into moist soil.
Reference 4 - 120V Receptacle. The second
duplex is a 120V 20A straight blade receptacle,
National Electrical Manufacturer’s Association (NEMA)
number 5-20R. This receptacle accepts NEMA plug
numbers 5-15P and 5-20P. Each receptacle on this
duplex is capable of drawing 20A.
Reference 5 - 120V Receptacle. The generator
has a control panel with two duplex (two receptacles in
a common housing) receptacles. The one duplex is a
120 volt (V) 15 amp (A) straight blade receptacle,
National Electrical Manufacturer’s Association (NEMA)
number 5-15R. This receptacle accepts NEMA plug
number 5-15P. The duplex is capable of drawing 15A
out of either receptacle or a combination of both.
Reference 6 - Oil Drain Plug. Refer to your
Honda engine manual for oil change
recommendations.
Reference 7 - Engine Stop Switch. The red
engine stop switch is located on the engine. Always
locate this switch and be familiar with its location
before operating the generator.
Reference 8 - Starting/Stopping Instructions.
Reference 9 - Air Cleaner. Refer to your Honda
engine manual for air cleaner care.
Reference 10 - Super Silent Muffler. 4 dB less
than Honda’s standard muffler.
Reference 11 - Gas Cap with Gauge. The gas
cap is extra large, creating a large hole for refilling and
a comfortable grip. You can always monitor the fuel
level without removing the cap by using the fuel level
indicator built into the gas cap.
Reference 12 - 6.5 Gallon Gas Tank. Large tank
allows for extended run capabilities. Always allow
room for gasoline expansion by not filling the gas tank
completely full.
Reference 13 - Generator Head. The electricity
producing part of the generator.
Reference 14 - Vibration Isolation Mounts. The
engine and generator are mounted on rubber cylinders
that absorb most of the engine vibration. This feature
eliminates the tendency of the machine to “walk” which
is common in engine powered equipment.
Reference 15 - Recoil. Grasp firmly when
starting engine.
Reference 16 – Fuel Valve Lever. The generator
tank has an ON-OFF valve mounted underneath the
tank. Always keep this valve closed when the
generator is not in use.
Reference 17 - Choke Lever. Used during cold
starts. Refer to the starting/stopping instructions and
the Honda engine manual for usage.
Low Oil Shutdown. The Honda engine is
protected against damage resulting from low oil level.
As the oil falls below the safe level, the engine
automatically shuts off (the engine stop switch remains
in the on position). The engine will not start until the
oil is refilled to above the safe level.
INTRODUCTION
Before starting your generator, thoroughly study
the instructions and cautions in this manual to assure
you are fully acquainted with the operation of all
components of this generator. Proper preparation,
operation and maintenance will result in operator
safety, best performance and long life of the generator.
For detailed engine operation and maintenance always
refer to the Honda engine owner’s manual furnished
with the generator (Honda refers to the 13 Hp engine
as a GX390).
NorthStar is constantly improving its products.
The specifications outlined herein are subject to
change without prior notice or obligation. The
purchaser and/or user shall assume liability of any
modification and/or alterations on this equipment from
original design and manufacture.
Before using, the user shall determine the
suitability of this product for its intended use and
assumes liability therein.